HOLD A DOZEN GOLDEN YELLOW ROSES!
What You Need:
Lining (same color of tulle)
elastic (1"-1.5" thick)
Use craft paper to cut a large square. Then measure your hip measurement out from one corner (just keep pivoting the ruler to make lots of marks and connect the dots at the end to get your rounded edge). Repeat the process from the same corner to find the bottom of your skirt line, but add the waist measurement to your total skirt length for that number (so if your length is 22" and your waist measurement is 6.5", then measure out 28.5"). Cut out your pattern paper.
Cut squares of tulle that are big enough to fit your paper pattern when the the square is folded in half, and then folded in half again to make a smaller square that is 1/4 the original size. Using the example numbers above, you would need a square that was 57" wide (28.5 x 28.5 = 57) when unfolded. The number of squares you have determines the number of layers your skirt will contain, so buy your fabric yardage accordingly. If you can't find a tulle wide enough to get a square as big as you need, you'll have to sew two pieces side by side first before cutting your square down to size.
Fold your large square in half, and then in half again, and place the pattern so that the corner with the middle of the square is near the waistline of the pattern. Use fabric scissors to cut along the waistline and bottom hemline. Unfold the tulle, and you should have a giant tulle donut!
Cut out as many layers as you want for the tulle. Cut out an extra piece for your lining. Either hem the lining so it's shorter than the tulle, which is what you want, or serge it on a serger or baby lock machine. Completely up to you. Don't over think it.
To make your waistband, pin the elastic around your natural waist so that it feels snug but not too tight. Wiggle out of the elastic and sew it together at that point. Trim the ends to 1/2" long, fold the ends down, pin in place, and sew those down to flatten them.
Use marking chalk to mark 4 equal sections on the waistline of your tulle circle. Do the same with the inside edge of your waistband. Use the marks to line up your waistband with your fabric and pin with 4 straight pins at each mark (you'll pin the bottom inside edge of the waistband onto the top of the fabric layers.
Since your elastic waistline is probably smaller than your fabric opening (that's measured to the widest part of your hips), you'll notice that there is some gapping where the sections of tulle are longer than the elastic. In that case, just pin the middle of each gap to the middle of the elastic section so you now have 8 pins total holding your layers together.
To sew your layers together, turn your skirt inside out and sew a few stitches near where a pin is holding the layers together. While the needle is in the down position, pull your elastic towards you until the fabric gap straightens out and sew along the waistband with a 1/2" seam allowance on the fabric layers. Continue this process of pulling the elastic and the fabric straight and sewing until you get all the way around the waistband.